4-Max
The Electric Flight Specialists

PP-NESC15AU - 15A ESC
(Brushless Electronic Speed Controller)

Specifications

Features

• Soft Starting – Reduces the stress on the airframe.
• ESC comes with 3 male and 3 female connectors, so no more hunting around for connectors to get your new project in the air.
• Auto Timing – no need for manual selection.
• Self Checking
• Low Voltage Cut Off – Protect your batteries from damage due to excessive drain.
• Thermally Protected – The ESC will reduce the output power to the motor depending upon its temperature.
• Signal lost Protection – Upon loss of radio signal the ESC will stop the motor.
• Power on Protection – The motor will not start unless the throttle stick is in the off position when the power is applied.
• Simple Parameter Setting via the transmitter

Programmable Parameters

• Low voltage threshold: User can set the low voltage threshold according to cell count. The range is 2.65V, 2.85V and 3.1V, the default is 2.85 Volts per LiPo cell.
• Brake: Options are "On" or "Off". The default setting is “off”. We recommend that the brake is set to off unless a folding prop is used.
• Timing: Options are Low, Medium or High. The default setting is low. We recommend medium or High timing for all outrunners.
• Throttle Response: The time taken for the ESC to go from zero to full throttle. 0.25 ~ 4.00 seconds. The default is 0.25 seconds.
• Cut Off: Reduce power, or hard cut off. The default setting is reduce power.
• Start power: To set the ratio of output power when starting in range of 0% - 45%. The default setting is 0%.
• Governor mode: On or Off. The default is Off.
• Rotational direction: The direction of rotation can be changed by swapping any 2 of the 3 wires that connect to the motor.

* Please note that the BEC portion of the ESC should only be used on 2S and 3S systems. For 4S systems the BEC needs to be disabled an our dedicated UBEC should be used or a traditional receiver pack. Please click here for a diagram on how to wire up a UBEC

User Instructions

	15A ESC User Instructions (PP-NESC)
	How to wire up a UBEC