This mount has been designed for use with large
modern brushless outrunner motors.
It will
allow the motor to be moved forward to the correct position.
Slide the mount to the correct length then drill
through both tubes and inset bolt and secure with Nyloc nut (don't
over tighten).
Suitable for motor diameters from 35mm to 63mm.
Dimensions
-
Front Plate: 65mm x 65mm (approx)
-
Rear Plate: 70mm x 90mm (approx)
-
Length: 111mm, Extended Length: 155mm (approx)
Can be made shorter by cutting both tubes.
-
Weight: 162g (including all the nuts and bolts as shown in
photo
|