4-Max
The Electric Flight Specialists

ST Models DG1000
2010 0mm (79.1")

If you fancy something that is truely unique and stylish then the ST Models DG1000 could be the model for you

Based on the classic DG1000 glider, this gorgeous model is accurately moulded in impact resistant EPO foam, even those sexy wing tips! The wings are removable for easy transport by just releasing one screw and are re-inforced with carbon tube to ensure rigidity and strength. The aileron servos are pre-installed, as are the servo extension leads and each aileron hinge is formed by the EPO foam for best efficiency.

The fuselage is also moulded in EPO foam with carbon fibre re-inforcement and the elevator and rudder pushrods pre-installed and connected to their respective servos. Just bolt on the tail and the assembly is done!

Now we come to the clever bit! Not only do you get a powerful, 1500kv, outrunner brushless motor, propeller and ESC as standard, you get a unique motor retraction system to fold it away into the fuselage. That system is servo driven and cleverly controlled by a special mixer unit (supplied). Closing the throttle stops the propeller and motor before fully retracting and closing the doors. This all operates from the throttle stick alone. Just nudge the throttle open again and the motor swings up before operating. If you use the optional switched channel, you can opt top keep the motor out and just control the throttle as normal. When the motor is away, the model becomes a highly efficient glider and will stay aloft in minimal lift conditions.

Just fit a 3S 1300mAh Li-Po battery plus receiver of your choice and you're ready to go. The power is sufficient for a pretty rapid ascent and you will get many climbs from one charge.

Included with the kit are

• 4 micro servo and 1 high torque servo
• 1500kv brushless outrunner motor
• 18A brushless ESC

From opening the box to going flying will take less than one hour!

The ST Models DG1000 requires the following to complete (not included)

• A minimum of a four channel Transmitter and Receiver
• 3S 11.1v 1300mAh LiPo battery and charger

Specifications

Please Note: Due to size and weight limitations we are unable to ship kits outside of the UK