brushless motors LiPo batteries electronic speed controllers inrunner Motors outrunner motors HiTEC Futaba Transmitters and Receivers servos

4-Max
The Fixed Wing
Electric Flight Specialists

Est. 2007

<<<  Back
Tel: 01256 782 512
Click here to Check us out on Facebook and to get access to special offers and notifications of new releases

4M-ESC12A
12A ESC (Brushless Electronic Speed Controller)


4Max

4M-ESC12A
Please Click for a larger image

4-Max

ProgCard
Please Click for a larger image

Share on your Facebook Page





Specifications

Constant Current 12A
Burst Current 15A for 10 Seconds
Input Voltage Range 2-3 LiPo (6 - 12.6V DC)
BEC Voltage Range 2-3 LiPo (6 - 12.6V DC)
BEC Output 5.5V DC @ 2A (2-3 std analogue servos) SBEC
Weight (g) 15g (includes all wires and connectors)
Size (mm) 40mm x 18.5mm x 9.5mm (includes heatshrink)
Connectors supplied None


Features

  • Easy setting, easy operation using programming card.
  • Safe start-up system. The motor will not start no matter which position the throttle stick is when the battery is connected.
  • Automatic power cut-off. If the motor suddenly stops rotating or the radio signal is lost for more than 3 seconds, the power will automatically be cut off.
  • BEC provides power to receiver and servos (for ESC with BEC).
  • High rate switching Pulse Width Modulation (PWM): 16KHZ.
  • Over-heat protection. User set via the program card. 90°C - 140°C (7 choices)
  • Over-voltage protection.
  • Low-voltage cut-off. 2.9V - 3.5V User set via the program card (7 choices)
  • Timing mode; 0-30°(7 choices)
  • Break Strength is programmable via the program card (7 Choices)
  • Start up power is programmable via the program card (7 Choices)
  • Programming is very easy with the programming card.

VERY IMPORTANT - Please follow this setup procedure for your 4-Max 4M ESC

IF YOU WISH TO POWER YOUR RECEIVER AND SERVOS USING A 2S LiPo OR A 2S Li-ion BATTERY PLEASE CONTACT US FOR ADVISE ON HOW TO DO THIS.

Part Number Description Qty
4M-ESC12A 12A Brushless Electronic Speed controller Replaced by 4M-HESC12A
4M-PROGCARD Programming Card

User Instructions

ESC Programming Instructions
How to wire up a UBEC

<<<  Back Top